291-HDF

BERG Rotary Transmission Leadthroughs HDF

Rotary transmission leadthroughs serve as a rear inter face for fluid transmission into the spindle. A hydromechanic clamping unit or integrated clamping cylinder can be actuated with the media oil, air and coolant. The transmission of oil and coolant is possible at rotational speed.

PDF Data Sheet: BERG Rotary Transmission Leadthroughs HDF (291-HDF)

Details Ask a Question Request a Quote

ApplicationRotary transmission leadthroughs serve as a rear inter face for fluid transmission into the spindle. A hydromechanic clamping unit or integrated clamping cylinder can be actuated with the media oil, air and coolant. The transmission of oil and coolant is possible at rotational speed.

Design FeaturesThe HDF hydraulic rotary transmission leadthrough with integrated coolant feed was specifically designed for HSK, SK and CAPTO interfaces in combination with the hydro-mechanical clamping units. The rotary transmission lead-through runs in its own bearing and can be integrated in the spindle.

When the HDF is used with hydrodynamic, self-limiting clamping systems which are not pressurised with clamping pressure at rotational speed, a rotating pressure of 5 bar is to be applied to the clamping line for lubrication and cooling. The rotary transmission leadthrough can be mounted in any position.

For more information regarding this item (BERG Rotary Transmission Leadthroughs HDF) or other items, fill out the form below or contact our office directly:

Telephone: 815-962-5600
Fax: 815-962-4600
Location: 304 North Main St, Suite 104, Rockford, IL 61101-1101 USA
Email: infο@ΤΑCRοckfοrd.cοm

Add Comment		Alias
Full name
Position/Title
Company
Telephone
Fax
Email
Mailing Address

Receive a quote or more information on:

Questions or comments:

How did you hear about us?
Other:

Your preferred method of contact

Drawbar Adapters

Depending on the customer's requirements one or more media can
be transmitted from the end of the spindle (actuation and/or rotary
supply to the front HSK, SSK or Coromant Capto interface.

OSKL Tool Clamping Cylinders

OSKL rotating hydraulic cylinders are primarily designed for actuating SSK gripper, but are also suitable for operating other clamping and chucking systems.

Hense Pneumatic Rotary Actuators

Hense rotary actuators provide an effective and economic solution for angular or straight motion when high force and torque is required.

OHL and OHLK Tool Clamping Cylinders

Rotating hydraulic cylinders of the type OHLK..-1 and OHL..-1 are principally designed for actuating SK and HSK clamping sets. All coolant lubrication and compressed air supply variants are possible with a single device to meet the respective requirements. The control system is represented in the circuit diagram T 1345. Unlike spring actuated clamping and chucking systems, OHL(K) ..-1 hydraulic cylinders allow alteration of the clamping forces within wide limits. As the rotating cylinder is permanently connected to the spindle, no axial forces act upon the spindle bearings during tool release and ejection.