682.420.0100

Kelch HSK-A Reduction Sleeves for Straight Shanks with Inclined Clamping Surface (Whistle Notch)

DIN 69 882-5

Available for HSK-A 40, 50, 63, 80, 100

PDF Data Sheet: Kelch HSK-A Reduction Sleeves for Straight Shanks with Inclined Clamping Surface (Whistle Notch) (682.420.0100)

UseFor holding shank tools with inclined clamping surface (2 degrees), DIN 1835 type E and DIN 6535 type HE.

DesignPermissible concentricity deviation of hollow taper shank to location hole d 1 = 0.003 mm (measured at 3 x D cantilever length). Chucks are fine balanced according to ISO 1940-1 G 6.3 at 12,000 rpm.

Standard SpecificationClamping screw and adjusting screw included. From location hole d1 = 25 mm 2 clamping screws are included.

NoteFor an increased machining accuracy the bore tolerance is much reduced compared to DIN 1835.
Bored through adjusting screw for coolant. Other designs and sizes are available on request.


Was this information helpful? Provide feedback or ask a quick question about this item.


Your name:
Your company:
E-mail:

For more information regarding this item (Kelch HSK-A Reduction Sleeves for Straight Shanks with Inclined Clamping Surface (Whistle Notch)) or other items, fill out the form below or contact our office directly:

Telephone: 815-962-5600
Fax: 815-962-4600
Location: 304 North Main St, Suite 104, Rockford, IL 61101-1101 USA
Email: infο@ΤΑCRοckfοrd.cοm

Add Comment

Alias

Full name
Position/Title
Company
Telephone
Fax
Email
Mailing Address

Receive a quote or more information on:


Questions or comments:


How did you hear about us?
   Other:


Your preferred method of contact

Related

HSK-A Side Lock Holders (Whistle Notch)
HSK-A Side Lock Holders (Whistle Notch)

Available for HSK-A 32, 40, 50, 63, 80, 100

HSK-C Side Lock Holders
HSK-C Side Lock Holders

Available for 32, 40, 50, 63

HSK-A Reduction Sleeves for Morse Tapers with Tang
HSK-A Reduction Sleeves for Morse Tapers with Tang

Available for HSK-A 50, 63, 80, 100

HSK-A Reduction Sleeves for Morse Tapers with Thread
HSK-A Reduction Sleeves for Morse Tapers with Thread

Available for HSK-A 50, 63, 80, 100

HSK-C Weldon and Whistle-Notch Holders
HSK-C Weldon and Whistle-Notch Holders

The hole diameter and circular deviation tolerances have been significantly tightened up compared with DIN 1835 in order to achieve the highest levels of machining precision. Available for HSK-C 32, 40, 50, 63.

Page loaded in 0.1242 seconds.