682.420.0010
Kelch HSK-A Reduction Sleeves for Straight Shanks with Lateral Driving Surface, Conical Version
similar to DIN 69 882-4
Available for HSK-A 63, 100
PDF Data Sheet: Kelch HSK-A Reduction Sleeves for Straight Shanks with Lateral Driving Surface, Conical Version (682.420.0010)UseFor holding shank tools and lateral driving surface, DIN 1835 type B and DIN 6535 type HB.
DesignPermissible concentricity deviation of hollow taper shank to location hole d 1 = 0.003 mm (measured at 3 x D cantilever length). Chucks are fine balanced according to ISO 1940-1 G 2.5 at 25,000 rpm.
Standard SpecificationClamping screw included. From location hole d1 = 25 mm 2 clamping screws are included.
NoteFor an increased machining accuracy the bore tolerance is much reduced compared to DIN 1835. Other designs and sizes are available on request.
For more information regarding this item (Kelch HSK-A Reduction Sleeves for Straight Shanks with Lateral Driving Surface, Conical Version) or other items, fill out the form below
or contact our office directly:
Telephone: 815-962-5600
Fax: 815-962-4600
Location: 304 North Main St, Suite 104, Rockford, IL 61101-1101 USA
Email: infο@ΤΑCRοckfοrd.cοm
Related
HSK-A Reduction Sleeves for Straight Shanks with Lateral Driving Surface (Weldon)
Available for HSK-A 40, 50, 63, 80, 100
HSK-A Reduction Sleeves for Straight Shanks Slim Version
Available for HSK-A 63
HSK-A Reduction Sleeves for Straight Shanks with Inclined Clamping Surface (Whistle Notch)
Available for HSK-A 40, 50, 63, 80, 100
HSK-A Reduction Sleeves for Morse Tapers with Tang
Available for HSK-A 50, 63, 80, 100
HSK-A Reduction Sleeves for Morse Tapers with Thread
Available for HSK-A 50, 63, 80, 100
HSK-A Drill Chucks
Available for HSK-A 50, 63, 80, 100
LINS Cylindrical Linear Motors
Direct electric drive, high acceleration, extremely low noise, without reduction gear, no play at direction reversal, free of lateral forces, no rotor losses, and with NdFeB magnets. Contact us to adapt the electrical and mechanical design to your specific requirements.
HSK-A Collet Chucks for ER/ESX ER-11/16 Collets with Internal Thread
Available for HSK-A 40, 50, 63, 100
Submit your feedback